Table of Contents
Advertisement
PROBLEM
Small amount
of water in
the drum at
end of cycle
Noises
Vibration
Creasing
Dye transfer
TROUBLESHOOTING
POSSIBLE CAUSES
Water tank needs to
be emptied.
Environmental conditions
may be affecting
dryer operation.
Dryer is overloaded.
Dryer has a fault.
Beeps signalling the end
of a drying cycle.
Dryer has not been
levelled properly.
Dryer makes
unfamiliar noises.
Dryer is not installed on
a stable surface.
Dryer is not level.
Dryer is overloaded.
Cycle selection not
appropriate for the load.
Dryer is overloaded.
selected
DRYNESS LEVEL
too high for load type.
option
WRINKLE FREE
not selected.
White/light and coloured
items not separated
before drying.
Wet items left sitting in
the dryer for long periods
of time before drying.
WHAT TO DO
Refer to 'Emptying the water
collection tank'.
If conditions are particularly hot,
humid or cold, it is possible vaporised
water may re-condense in the drum
or on the inside of the door.
Remove some items from the dryer.
Continuous beeping or a musical
series of beeps with a message
displayed on the display.
Refer to 'Customising a dry cycle'.
End of cycle beeps can be turned off.
Refer to 'Drying cycle options'.
Refer to your installation guide for
guidance on levelling.
At the start of the cycle the dryer
may make some unfamiliar noises
when the compressor turns on.
This is normal.
Ensure the dryer is installed on a
flat, stable surface. Refer to your
installation guide for guidance on
levelling.
Ensure the dryer is correctly levelled.
Refer to your installation guide for
guidance on levelling.
Remove some items from the dryer.
Select the
EASY IRON
minimise creasing.
Remove some items from the dryer.
Try selecting a lower
Select the
WRINKLE FREE
rotate the load at the end of the
drying cycle. Refer to 'User warnings'.
Remember to separate white/light
and coloured items before placing
them in the dryer.
Refer to 'Sorting' for tips to prevent
dye transfer.
cycle to
.
DRYNESS LEVEL
option to
37
Advertisement
Table of Contents
