Assembly; Connecting The Probe Assembly - YEO-KAL 801C User Manual

Assembly

The YK801B comes already assembled. The only construction required is to connect the probe
assembly to the reader unit.

Connecting the Probe Assembly

To attach the probe assembly, first unscrew the knurled connector cap from the sensor connector
of the reader unit. The connector cap is attached to the reader unit by a chain so that it can be
replaced whenever the probe assembly is disconnected. To connect the probe assembly, align the
locating pin on the reader unit with the slot on the cable connector and push the cable connector
into the reader unit reciprocal connector then screw home the retaining ring. See Figure 6.
Figure 6 Probe connected to reader unit
10