Hussmann MWG Installation And Operation Manual page 18

D
3-4
RIP
INSTALLING OPTIONAL STAINLESS
STEEL SPLASHGUARDS
The O tainless steel splashguard is also
PTIONAL S
shipped inside the merchandiser. A
merchandisers have been leveled and joined, and
all drip piping, electrical and refrigeration work
has been completed, install the O
less steel splashguard and, if appropriate, the
lower front panel.
To Install Splashguards:
1. Check to be sure that all splashguard brackets
are level with the floor.
2. Position top of splashguard over the top edge
of the bracket as shown below.
3. Push the lower edge of the splashguard
toward the bottom of the bracket until it snaps
into place.
To Install Lower Front Panel
1. Position the lower front panel with the top
angled as shown in the illustration below.
2. The tabs extending from the upper front panel
assembly are designed to fit into the slots on
the top of the lower front panel.
3. Once the top is positioned, lift the panel up
and drop it into the grove at the top of the
splashguard.
O tainless steel splashguards may be
PTIONAL S
sealed to the floor using a vinyl cove base trim.
The size of trim needed will depend on how
much the floor is out of level.
To install the trim to the splashguard:
1. Remove all dirt, wax and grease from the area
of the splashguard where adhesion will be
necessary to ensure a secure installation.
2. Apply a good contact cement to the cove trim
and allow proper drying time according to the
directions supplied with the cement.
3. Install the trim to the splashguard so that it is
lying flush with the floor. D
TRIM TO THE FLOOR
4. If required by local health codes the Cove
Trim may be sealed to the floor, using a sili-
cone type sealer. Sealant must be removed
and replaced when servicing.
P/N 0378414G
P S
IPING AND PLASHGUARDS
all the
FTER
PTIONAL S
O NOT SEAL THE
.
tain-
Splashguard
Cement
Cove Trim
1.
Bracket
2.
Splashguard
3.
Splashguard
1. &
2.
Tab
Lower Front Panel
3.
Lower Front Panel
Lower Front Panel
Bracket
Base of
Case
Base of
Case