Hussmann MWG Installation And Operation Manual page 10

I
1-8
NSTALLATION
5. Return to the left end of the line up and
position the starter section of the top rail
as shown.
NOTE: The top rail
should not be installed
until the upper bumper
is securely in place.
6. Push the bottom portion of
the short top rail section down over the color
panel. It helps if you lift the top with your
other hand as shown. You will hear and feel
the trim "snap" into place.
NOTE: The trim
must "snap" to
be properly
positioned.
7. Use one hand to push the top rail toward the
rear of the case while using the other hand to
"snap" the top section down over the edge of
the light channel as shown.
Again, be sure
it "snaps"
into place.
8. Install full length top rails using the same
procedures. Continue installing the top rails
the length of the line up. Do NOT install last
section at this time.
9. Once all except the last sections of upper
bumper and top rail have been installed
refrigerate the case line up for at least six (6)
hours. The last sections of upper bumper
and top rail should be kept inside a refrig-
erated case or cooler during this time. This
will allow the bumpers and top rails to con-
tract.
P/N 0378414G
Push
Snap
Push
Snap
Push
10. Go to the right end of the line up and tap the
top rail and bumpers to close any gaps.
11. Measure and cut last
sections of top rail
and bumpers. Use a
miter box and fine-
tooth saw to cut last
bumpers and top rail
to length. Install the
last sections.
Note: If part of plastic top rail pops loose,
remove that section of top rail and re-install
according to Steps 6 and 7 above. Trying to re-
Lift
install only the popped part may not secure the
top rail, and may damage the top rail, color panel
and light channel.
12. Remove protective film from bumper and top
rail once installation is complete.
G F
LASS RONT
supplied silicone sealant to underside of end trim
and press firmly in place.
INSTALLING PARTITIONS
To join same temperature fixtures on different
defrost cycles, an acrylic partition kit is
required.
To join unlike fixtures, or like fixtures operating
at different temperatures, a 1
tition kit is required.
Instructions for installing these partitions are
included with the kits.
Miter Box
C O :
Apply field-
ASE NLY
1 / in. (38 mm) par-
2
Bumper