Hussmann FW Technical Data Sheet page 3

Wide Island Display with Solid Walls
Dimensions shown as inches & (mm).
NSF Certification
This merchandiser model is manufactured to meet ANSI/NSF
(National Sanitation Foundation) Standard #7 requirements for
construction, materials & cleanability.
P/N 0465900_C
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM
Impact Excel
Low / MediumTemperature
REFRIGERATION DATA
Note: This data is based on store temperature and
humidity that does not exceed 75°F and 55% R.H.
M
Discharge Air (°F)
Evaporator(°F)
Unit Sizing (°F)
Btu/hr/ft M
Parallel
Conventional
DEFROST DATA
M
Frequency (hr)
Defrost Water (lb/ft/day)
(± 15% based on case configuration and product
loading).
E M
LECTRIC
Temp Term (°F)
Failsafe (minutes)
G
AS
Duration (minutes)
O Not Recommended
FFTIME
Standard Defrost Thermostat
Close on rise: close 48°F — open 33°F
CONVENTIONAL CONTROLS
Low Pressure Backup Control — CI/CO *
M +22°F / +10°F
ED
FF –17°F / –29°F
IC –27°F / –39°F
Indoor Unit Only, Pressure Defrost Termination*
*Use a Temperature Pressure Chart to determine PSIG
conversions.
Estimated Charge (lb)**
4 ft
8 ft
12 ft
**This is an average for all refrigerant types. Actual
refrigerant charge may vary by approximately half a
pound.
Length Added to Lineup by Each
End or Partition (in.)
FW
FF IC
ED
+24 –12 –22
+19 –20 –30
+17 –23 –33
FF IC
ED
415 530 575
430 550 600
FF IC
ED
24 24 24
1.6 1.5 1.2
FF IC
ED
48 48 48
60 60 60
NA 15 18
Not Recommended
1.7
2.5
3.7
2
3 of 7