Hussmann IMPACT ED1 Installation Instructions Manual page 7

Medium Temperature, Euro Deli Solid Front Models
Relocate Hinge
Assembly One Set Of
Holes Away From Wedge
Top Extrusion
Drill 0.140 Dia. Pilot
Holes (4 Places)
Figure 11. Relocating Hinge Assembly
Top Extrusion
Parent Case
Relocated
Hinge Assembly
Figure 12. Fastening 30°/45° Wedges
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Parent Case
Drill 0.140 Dia. Pilot
Holes (6 Places)
Hinge
Assembly
Wedge
Two Pre-Drilled Holes
For Locating Hinge
Assembly
30°/45° Inside and Outside Wedges
7 The 30°/45° wedge joining
requires the relocation of one
hinge assembly.
A. Unfasten the parent case
hinge that is closest to the
wedge end of the case. Move the
hinge assembly one set of holes
away from the wedge.
Four holes will line up with
Wedge
existing holes and four holes
will have to be drilled.
B. Align the top extrusion and
insert the hinge assembly similar
to the joining plate. Two holes
in the hinge assembly will locate
the assembly by lining up with
two pilot holes drilled in the
wedge top extrusion.
The six remaining holes in the
hinge assembly will be on the
parent case side of the joint and
require drilling 0.140 diameter
pilot hole for the screws. (
No. 28 drill bit)
Use #8 screws to fasten the
hinge assembly.
P/N 0406929
9
/ or
64
7