Cisco MDS 9100 Series Installation Manual page 35

Chapter 2 Installing the Cisco MDS 9100 Series
Figure 2-1
1 Front rack-mount bracket
Install the slider rails in the rack. Position one of the slider rails against the rack mounting rails and align
Step 3
the screw holes as shown in
or the Cisco MDS 9124 Switch, see
Note
Step 4 Attach the slider rail using two 12-24 screws or two 10-32 screws, depending on the rack rail thread type.
For racks with square holes, insert the 12-24 cage nuts in position behind the mounting holes in the slider
rails.
Repeat with the other slider rail on the other side of the rack.
a.
OL-16187-01
Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series
Figure
Depending on when you purchased your Cisco MDS 9124 Switch, you may have straight slider
rails like those shown in Figure
in Figure 2-3. Refer to the illustrations that show the type of rails that came with your switch.
1
2 C bracket
2-2. If you are using the notched slider rails for the Cisco MDS 9134
Figure 2-3.
2-2, or you may have the notched slider rails like those shown
Cisco MDS 9100 Series Hardware Installation Guide
Installing the Switch in a Cabinet or Rack
2
2-7