A P P E N D I X B Connector And Cable Specifications; Sfp Module Ports; Dual-Purpose Ports - Cisco CATALYST 2960 Hardware Installation Manual

Appendix B Connector and Cable Specifications

SFP Module Ports

The Catalyst 2960 switch uses SFP modules for fiber-optic and copper uplink ports. See the
Catalyst 2960 switch release notes for a list of supported SFP modules.
Figure B-2
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments.
Figure B-3

Dual-Purpose Ports

The Ethernet port on a dual-purpose port uses standard RJ-45 connectors.
The SFP module slot on a dual-purpose port uses SFP modules for fiber-optic and copper uplink ports.
See the Catalyst 2960 switch release notes for a list of supported SFP modules.
Note The auto-MDIX feature is enabled by default. For configuration information for this feature, see the
switch software configuration guide or the switch command reference.
OL-7075-09
Fiber-Optic SFP Module LC Connector
Copper SFP Module RJ-45 Connector
Pin Label
1 TP0+
2 TP0-
3 TP1+
4 TP2+
5 TP2-
6 TP1-
7 TP3+
8 TP3-
1 2 3 4 5 6 7 8
Figure B-4
Catalyst 2960 Switch Hardware Installation Guide
Connector Specifications
shows the pinouts.
B-3