Table of Contents
Advertisement
PW6K1R1E Wiring and Setup
Specifications
5
6
After the PW6K1R1E has received its IP address, the following table describes the
LEDs in the normal running mode. If the communication is lost, the PW6K1R1E
reverts back to the "waiting for IP address" mode:
LED
1
2
3
4
5
6
2.11 Specifications
The interface must be used in low voltage, class 2 circuits only.
The installation of this device must comply with all local fire and electrical codes.
Power Input
Power Output • 12VDC @ 700mA maximum (reader and AUX outputs combined)
Output
Inputs
12
www.honeywell.com
Input IN2 Status: OFF = Inactive, ON = Active, Flashing = Trouble
Input IN3 Status: OFF = Inactive, ON = Active, Flashing = Trouble
DESCRIPTION
On-line, encryption disabled = 0.8 second ON, 0.2 second OFF
On-line, encryption enabled = four pulses, 0.1 second ON, 0.1 second OFF per
second
Flashes when there is host communication
Flashes when data is received from either reader
Input IN1 Status: OFF = Inactive, ON = Active, Flashing = Trouble
Input IN2 Status: OFF = Inactive, ON = Active, Flashing = Trouble
Input IN3 Status: OFF = Inactive, ON = Active, Flashing = Trouble
• PoE Power Input 12.95W, compliant to IEEE 802.3af
- OR -
Notes:
• A +12V power input must be powered by a UL 294/UL 609 Listed power
supply with appropriate ratings (12Vdc, 900mA) and the capability to
provide adequate standby power.
• If the PW6K1ICE is powered by Power-Over_Ethernet (POE), it must be
powered by a Listed (ALVY) Altronix, Model NetWay1 POE Injector.
NetWay1 must be powered by a UL 294/UL 609 Listed power supply with
appropriate ratings (24Vac/dc, 1.2A) that is capable of providing adequate
standby power.
• Reader (TB3) 12 VDC (10.3 through 12.6) @ 150mA maximum
• AUX (TB5) 12 VDC (10.7 through 13.0) @ 700 mA maximum
• Form-C Contacts rated at 5A @ 28VDC
• 4 unsupervised/supervised, End of Line resistors
• 1k/1k - ohm, 1% 1/4W watt standard
•12VDC 10%, 900mA maximum
Advertisement
Table of Contents
