Final Check List - Hoshizaki KM-900MAH50 Instruction Manual

Modular crescent cuber

Hide thumbs Also See for KM-900MAH50:

Table of Contents

7. FINAL CHECK LIST

1) Is the icemaker level?

2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F all year

around?

3) Is there at least 6" clearance around the icemaker for maintenance or service?

4) Have all shipping carton, tapes and packing been removed from the icemaker? Is the cube

guide in its correct position?

5) Are all components, fasteners and thumbscrews securely in place?

6) Have all electrical and piping connections been made?

7) Has the power supply voltage been checked or tested against the nameplate rating? And

has a proper ground been installed in the icemaker?

8) Are the Water Supply Line Shut-off Valve and Drain Valve installed? Has the water supply

pressure been checked to ensure a minimum of 10 PSIG and a maximum of 113 PSIG?

Note: The icemaker may stop running when the water supply is OFF, or if the pressure is

below 10 PSIG. When the proper water pressure is reached, the icemaker automati-

cally starts running again.

9) Have the compressor hold-down bolts and refrigerant lines been checked against vibration

and possible failure?

10) Has the end user been given the instruction manual, and instructed on how to operate the

icemaker and the importance of the recommended periodic maintenance?

11) Has the end user been given the name and telephone number of an authorized service

agent?

12) Has the warranty tag been filled out and forwarded to the factory for warranty registration?

Table of Contents