Daewoo KOR-616T2S Service Manual page 29

(1) Remove the gasket door(A07) from door painting ass'y(A05).
(2) Remove the door frame(A01) from door painting ass'y(A05).
(3) Remove the barrier screen outer(A02) and the supporter barrier screen outer(A03).
(4) Remove the hook spring(A09) and the hook(A08).
(5) Remove the hinge stopper top ass'y(A04).
(6) Remove two screws(A11) which secure the handle door(A10).
(7) Rmove the handle door(A10) from the door frame(A01).
(8) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part 'A'.
1) Loosen two screws on the top hige stopper,
and then push the door to contact the door
seal to oven front surface.
2) Tighten two screws.
(2) To reduce gap located on part 'B'.
1) Loosen three screws on bottem hinge stopper,
and then the door to contact the door seal to oven front surface.
2) Tighten three screws.
(3) To reduce gap located on part 'C'. (See Fig. A)
1) Loosen a screw on the interlock switch assembly located at the bottom of the oven body.
2) Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.
3) Tighten a screw.
(4) To reduce gap located on part 'D'.(See Fig. B)
1) Loosen a screw on the interlock switch assembly located at the top of the oven body.
2) Follow step (3) 2) and 3).
Interlock
monitor
swtich
Hook
NOTE
: A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
Secondary
interlock
switch
Mounting screw
Fig. A
Mounting
screw
Hook
Primary
interlock
switch
28
A
Less
Clock
B
Fig. B
D
Stop Defrost
1 2 Quantity Weight Time
Lock Auto cook Watt g
Power Defrost +1min
Auto Cook
1. Beveroge
2. Soup
3. Casserole
4. Vegetable
5. Fish Fillets
START
STOP
More Speedy
CLEAR
C
2 .