Measurement Of The Microwave Output Power - Daewoo KOR-616T2S Service Manual

MEASUREMENT OF THE MICROWAVE OUTPUT POWER

Microwave output power can be checked by indirectly measuring the temperature rise of a certain amount
of water exposed to the microwave as directed below.
Procedure
1. Microwave power output measurement is made with the microwave oven supplied at rated voltage and
operated at its maximum microwave power setting with a load of 1,000±5cc of potable water.
2. The water is contained in a cylindrical borosilicate glass vessel having a maximum material thickness
of 3 mm and an outside diameter of approximately 190 mm.
3. The oven and the empty vessel are at ambient temperature prior to the start of the test.
The initial temperature of the water is 10±2°C (50±3.6°F).
It is measured immediately before the water is added to the vessel. After addition of the water to the
vessel, the load is immediately placed on the center of the shelf which is in the lowest normal position.
4. Microwave power is switched on.
5. Heating time should be exactly 47 seconds (KOR-
816T) or 52 seconds (KOR-616T).
Heating time is measured while the microwave
generator is operating at full power.
The filament heat-up time for magnetrons is not
included.
6. The initial and final water temperatures are selected so
that the maximum difference between the ambient and
final water temperatures is 5K.
7. The microwave power output P in watts is calculated from the following formula:
P = 4187 x
• T is actual temperature rise.
• t is the heating time.
The power measured should be 900W(KOR-816T) 800W(KOR-616T) ± 10%
CAUTION:
1. Water load should be measured exactly to 1 liters.
2. Input power voltage should be exactly 230 volts as specified.
3. Ambient temperature should be 20±2°C (68±3.6°F)
T/t
Tray
19
Water Load