7) Remove the Rubber Cap covering the Overflow Pipe in the Water Tank. Remove the Over-
flow Pipe by turning it counterclockwise. Drain the Water Tank. Replace the Overflow
Pipe, the Rubber Cap and the Insulation Panel in their correct position.
8) Repeat the above steps 15) through 26) in "[a] CLEANING PROCEDURE" two times to
rinse thoroughly.
9) Close the Cleaning Valve.
10) Move the Control Switch to the "ICE" position.
11) Replace the Front Panel in its correct position.
12) Clean the Storage Bin with water.
13) Turn on the power supply, and start the automatic icemaking process.
A1OA10A9908
27