Table of Contents
Advertisement
Before operating the icemaker, the Bin Control Thermostat Bulb must be set
correctly.
5) Set the Bin Control Thermostat Bulb as follows. See Fig. 3.
(a) Take off the shipping tape securing the Thermostat Bulb Holder. Remove the Ther-
mostat Bulb Holder from the Shipping Hook by lifting it up and shifting to the right.
(b) Slide the Thermostat Bulb Holder down through the hole located in the bottom of the
icemaker until it is placed in the Bracket.
(c) Insert the Plug into the Receptacle on the Holder. Check to see that the Plug is
locked into the Receptacle.
6) Level the icemaker/Storage Bin in both the left-to-right and front-to-rear directions.
Adjust the Ice Bin Legs to make the icemaker level.
7) Replace the panels in their correct positions.
CAUTION
Fig. 3
12
A1OA10A9908
Hide quick links:
Advertisement
Table of Contents
