Advertisement
AVR11 engelsk manual
11/01/98 10:46
Auto Tuning
1. Press the
FM/AM 6
the tuner as an input and the desired
frequency band.
2. Press the
SEEK /STEREO #
button, so that the AUTO indicator in the
display goes on.
3. Press the
TUNING/PTY
button once and tuning will start in the
direction indicated. The tuner will stop at
the next station with sufficient signal
strength.
Preset Memory
Up to 30 stations may be stored in the
receiver's memory for easy recall using
the front panel controls or the remote.
To enter a station to the memory, first
tune to the station using the steps
outlined above in the Manual Tuning
section. Then:
1. Press the
MEMORY @
front panel. Note that the
in the information display window will
illuminate and flash.
Side 11
Operation
2. Within five seconds, press the station
preset
button corresponding to the
!
memory location where you wish to store
this station's frequency.
• To enter a station to memory location
button to select
"30" press only the "
3. Repeat the process after tuning to any
additional stations to be preset.
Recalling Preset Stations
To select a station that has previously
been entered into the preset memory
⁄¤
simply press the station preset
&
on the front panel or the numeric
buttons on the remote corresponding to
the desired station's location. To select
the station in location "30", press the
button only.
• When you select a station using this
method the unit will automatically
switch to the tuner as its input.
Preset Station Scan
To automatically scan through the sta-
tions that have been entered to the preset
memory, press the
on the remote. The tuner will automati-
button on the
cally begin to search through the list of
indicator
stations, stopping for four seconds at each
MEM
one. Press the
stop the scan at your desired station.
11
RDS OPERATION
Your AVR11 is equipped with RDS (Radio
Data System), which brings a wide range
of information to FM radio. Now in use in
many countries, RDS is a system for
transmitting station call signs or network
information, a description of station
programming, text messages about the
station or specifics of a musical selection
and the correct time.
" button.
As more FM stations become equipped
0
with RDS capabilities, the AVR11 will
serve as an easy to use center for both
information and entertainment. This
section will help you to take maximum
advantage of the RDS system
RDS Tuning
buttons
!
To tune stations that are broadcasting
e
RDS data press the
the front panel and note that the
indicator illuminates in the front panel
display window.
0
Next, press the
in either the
unit will automatically seek the first
station with RDS data and stop there. The
station name or programme service
information will be displayed in the
information display window in place of
the normal frequency display.
P•SCAN d
button
Press the
again to tune to the next RDS station.
Remember that the
button again to
be pressed again to tune all stations, not
P•SCAN
just those sending RDS data.
RDS ^
button on
RDS
button
TUNING/PTY &
⁄
or
direction. The
¤
button
TUNING/PTY &
button must
RDS ^
Advertisement
