Hp-Ib Address And Connection Of The Wafer Prober - HP 4062UX Installation Manual

HP-IB Address and Connection of the Wafer Prober

The user is responsible for determining the HP-IB address of the wafer prober, if a wafer
prober is installed in the HP 4062 system. Hewlett-Packard, however, recommends setting the
HP-IB address of the wafer prober to the default address included in the SYSCONFIG le
(refer to the \Customizing the Wafer Prober" in Chapter 5). See the documentation of the
wafer prober for information about HP-IB remote controlling.
If the wafer prober is not listed in the SYSCONFIG le, the wafer prober is not supported.
After setting the HP-IB address of the wafer prober, connect the wafer prober to the HP-IB
interface card of the controller using the HP-IB cable.
If the controller, however, is model 340 or 345 used as a system controller in a diskless cluster,
connect the wafer prober to the built-in HP-IB interface (select code 7) of the controller.
Use 25 for select code (series 300 computers) or for logical unit number (series 700
computers). Select code and logical unit number are set in the SYSCONFIG le. The default
setting of the select code and the logical unit number in the SYSCONFIG le is 25. For
details about wafer prober setting, see \Customizing the Wafer Prober" in Chapter 5.
4-30 System Installation