Table of Contents
Advertisement
Line Voltage
100 Vac or 120 Vac
220 Vac or 240 Vac
Main power cable installation must be performed by trained service personnel
Warning
or electrician only. Incorrect installation will result in serious injury to operating
personnel and damage to equipment.
Do
not
Caution
inspection of all system instruments. This will protect the system instruments
from damage and service personnel from injury. Refer to \Testing Each
Instrument".
Use the following instructions for installing the main power cable:
1. Set the main power switch of the PDU to
OFF.
3. Remove the rear panel by removing the four
screws.
4-6 System Installation
Table 4-3. Maximum Current for PDU
HP Part Number
04062-60201
04062-60202
connect the main power cable to the outlet at your site until after the
Total Maximum
Maximum Current
Current
20 A
10 A
2. Open the rear door and disconnect all the
power cables of the instruments and hour meter.
4. Remove the chassis ground cable of the PDU
from the cabinet frame.
of Each Outlet
10 A
6 A
Advertisement
Table of Contents
