Extended Non-Use - U-Line UACP115-IS01A User's Manual And Service Manual

USER GUIDE

Extended Non-Use

If the ice machine is moved, not used for an extended
period of time, or will be in an area that will be near
freezing temperatures, it is necessary to remove any
remaining water in the ice-making system.
CAUTION
!
This ice machine must have all water drained and
removed to prevent ice machine damage as well
as possible water damage to the surrounding
area in freezing conditions. These damages are
not covered under warranty.
CAUTION
!
Do not use any type of anti-freeze or other solu-
tion as a substitution for properly draining the
ice machine.
WARNING
!
Risk of electrical shock or personal injury could
occur due to moving components, if machine
compartment access cover is removed before
unplugging the ice machine.
CLEAN THE ICE MACHINE
Cleaning the ice machine will help prevent mold and
mildew growth as well as sanitize the ice machine for
storage or when it is put back into service.
(SEE CLEANING SECTION OF THIS GUIDE)
WINTERIZATION
CAUTION
!
If the unit will be exposed to temperatures of
40°F (5°C) or less, these steps must be followed.
Draining and Removing Water from the Ice-Mak-
ing System
1. Turn off the water supply to the ice machine.
2. Disconnect the water supply fitting at the inlet of the
water valve.
3. Change the electronic control to the "CLEAN" position
for approximately one (1) minute. This will energize
and open the water valve and remove most of the
water from the water valve and the water valve's
outlet water line to the reservoir.
Extended Non-Use
Water Supply
Service Loop
to Shut-Off Valve
4. Change the electronic control to the "OFF" position.
This will energize and open the drain valve to drain the
reservoir and the ice machine drain system.
5. Unplug the ice machine from the electrical outlet.
6. Remove the access cover from the rear of the ice
machine.
26
u-line.com
Water
Supply Line
Clamp and
Screw
Water Supply
Line
Compression
Fitting
Water Valve
Inlet
Access Cover