Optional Modules And Devices - Honeywell FIre-LITe ALArms MS-9600LS Manual

Optional Modules and Devices

2.6 Optional Modules and Devices
WARNING: RISK OF ELECTRICAL SHOCK AND EQUIPMENT DAMAGE
!
DISCONNECT ALL SOURCES OF POWER (AC AND DC) BEFORE INSTALLING OR REMOVING
ANY MODULES OR WIRING.
FACP Keypad/Display Removal
Removal of the keypad/display is normally not necessary. If, however, it becomes necessary to
replace the keypad/display, access the auxiliary trouble bus connectors at J16 and J17 or install the
DACT-UD2 option module on J2, the Keypad/Display can be removed by inserting a Phillips
screwdriver into each of the three holes located in the flexible covering of the Keypad/Display and
loosening the three mounting screws. Note that it is not necessary to disconnect the cables between
the Keypad/Display and the main circuit board unless the unit itself is being replaced. Carefully lift
the Keypad/Display and rest the unit at the bottom of the main circuit board.
NOTE: When installing the DACT-UD2, the main motherboard must be removed from the
chassis. Unplug the power supply cable from J1 before proceeding.
MS-9600LS Series Manual — P/N 52646:B2 2/12/2010
Keypad/Display Mounting
standoff
standoff
screw
Keypad/Display Mounting
Screw Access Holes
Figure 2.10 Keypad/Display Removal
Screw Access Hole
screw
Installation
screw
screw
screw
screw
51