Advertisement
3-4
C
Pull filter (C) inside out through filter
frame.
3-7
Place filter on top of cup as shown and
push firmly into cup.
3-9
F
Final filter
How to replace
The final filter assists in returning clean air
to the room. The filter is located on the
side of the cleaner body.
When it becomes dirty, it must be
replaced. Replace with part no.
59136-022.
Disconnect cleaner from electrical out-
let.
To replace, press down on grill tab (F)
and remove grill. Remove the felt filter (G)
and replace with a new one.
3-5
Brush the surface of filter to remove any
clinging litter. (Filter may be washed in
warm water. It must be completely dry
before replacing in cleaner. Do not use
cleaner without filter in place.)
3-8
E
Place bottom of cup (E) first, then pivot
cup into position. Press top of cup to
snap it into place.
NOTE: Filter must be in place for cup
to latch.
3-10
G
To replace the filter grill, insert tabs (H) at
the bottom of the grill into slots (I) in the
cleaner body. Press on grill to snap it into
position.
3-6
Push filter back through frame.
Rug and floor
nozzle
H
To maintain the cleaning effectiveness of
your rug and floor nozzle, the brushes
may need to be replaced occasionally.
I
See your nearest Hoover Factory Service
Center or Authorized Warranty Dealer
(Depot) for new brushes.
Lubrication
The motor is equipped with two bearings.
These bearings contain sufficient lubrica-
tion for the life of the motor. Therefore, do
not add lubricant to either motor bear-
ing.
Continued
5
Advertisement
