How To Use - HoMedics HUM-WM75 Instruction Manual And Warranty Information

Cool & Warm Mist Ultrasonic Humidifier
Control Panel

How To Use

CAUTION: This appliance has a polarized plug (one blade wider than the
other). To reduce the risk of shock, this plug is intended to fit only one
way in a polarized outlet. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to defeat this safety feature. To do so could result in an
electric shock hazard.
Oscillating Head &
Nozzle
Fig.1
6
Oscillating
ON/OFF Button
Mist Decrease
Button
Warm/Cool Mist
Indicator Light Ring
Power Knob
Plug unit in to a 120 volt AC electrical outlet. Push the POWER ON/OFF ( )
button to turn unit on.
ATTENTION: When the water in the tank is almost empty, the power will shut off to
indicate to the user to refill water.
Mist Increase and Decrease
There are 7 different levels of mist output from Lowest to Highest. To increase the
mist output, press the MIST INCREASE (
reached. When the maximum mist output has been reached, the indicator ring light
will blink once and will blink each time the MIST INCREASE button is pressed.
To decrease mist, press the MIST DECREASE ( ) button until the mist has
decreased to the output level desired. When the minimum mist output level has
been reached, the indicator ring light will blink once and will blink each time the MIST
DECREASE button is pressed. (Fig.2)
Warm and Cool Mist Control
The humidifier is equipped with the option to select warm or cool mist. Each time
the unit is turned on it will start producing cool mist. The Warm/Cool mist indicator
ring will glow with a blue light. To select Warm Mist, press the WARM/COOL MIST
button. When warm mist is selected, the mist indicator ring will change from blue
to red and warm mist will start being produced. To return to cool mist, press the
WARM/COOL MIST button again. The mist indicator ring will change from red to
blue. (Fig.2)
Warm/Cool Mist Button
Mist Increase
Button
Power ON/OFF Button
Fig.2
) button until the desired mist output is
7