Video System Adjustments - Sony DCR-SR32E Manual

1-6.

VIDEO SYSTEM ADJUSTMENTS

1. Function of Each Button on Video System Adjust-
ment Screen
Click the [VIDEO SYSTEM ADJUSTMENT] button on the Main
Menu screen, and the "VIDEO SYSTEM ADJUSTMENT"
screen in Fig. 6-1-9 will appear.
2
1 [To Menu] button
The Main Menu screen comes back.
2 [Preparation] button
Notes for adjustment or jigs used are displayed.
3 [Start] button
"Video Adjustment" starts.
4 [Release Data Setting] button
The data setting at the adjustment is cancelled.
During the data setting, the button color changes from "white"
to "red". When the data setting is cancelled, the button color
returns to "white".
(Use this button when an error occurred in the video adjust-
ment. If the adjustment completed successfully, the data set-
ting is automatically cancelled and the button color returns to
"white".)
2. Adjustment Items of VIDEO System Adjustment
The adjustment items of video system adjustment are as listed in
Table 6-1-4. The Automatic Adjustment Program executes the ad-
justment items if the VIDEO Adjustment Start button is clicked.
Button
Name
Origin Oscillation
(Note)
Check
S VIDEO OUT Y
Level Adj.
S VIDEO OUT
VIDEO
Chroma Level Adj.
Adjustment
VIDEO OUT Level
Check
Note: The Automatic Adjustment Program does not support.
DCR-SR32E/SR33E/SR42/SR42A/SR42E/SR52E/SR62/SR62E/SR72E/SR82/SR82C/SR82E_ADJ
3
4
Fig. 6-1-9
Adjustment Measurement Point
R2108 (Pin B3 of IC2101)
on VC-489 board
Y signal terminal of S VIDEO plug of
A/V jack (75 ohm terminated)
Chroma signal terminal of S VIDEO
plug of A/V jack (75 ohm terminated)
VIDEO terminal of A/V jack (75 ohm
terminated)
1
Measuring
Instrument
Frequency
counter
Oscilloscope
Oscilloscope
Oscilloscope
Table 6-1-4
6-15
Adjusting Address
Block Page Address
- - -
10 60 4400
10 60 4401, 4402
- - -