Cisco 2654T6 Repacking Manual page 22

Repackaging the Routers
Repackaging the Miscellaneous Accessories
Step 1
Step 2
Step 3
Reassembling the Accessories Package
Step 1
Step 2
Step 3
Cisco XR 12416 and Cisco XR 12816 Router Chassis Installation Guide
A-22
To repackage the all of the miscellaneous accessory pieces, follow these steps:
Put the box containing the front cover for the power shelf and upper blower
module into the large miscellaneous accessories box.
Put all of the other miscellaneous accessory pieces in the box.
Close and seal the carton.
Figure A-2 shows an exploded view of the pieces that make up the accessories
package for the router. To reassemble the accessory box package, use
on page A-5 as a reference and follow these steps:
Place the bottom accessories package cap open side up on the floor.
To insert the accessory boxes into their slots in the bottom cap, follow these steps:
Insert the box containing the center-mount rack-mounting brackets in the
a.
center slot closest to the back panel of the router.
Set the box containing the rack-mounting platform against the box containing
b.
the center-mount rack-mounting brackets.
Insert one vertical cable-management trough box on either side of the box
c.
containing the rack-mounting platform.
Place the miscellaneous accessories box on top of the rack-mounting
d.
platform box, between the two trough boxes.
Place the top accessories package cap over the ends of the accessories boxes and
push it down to hold all the boxes together.
Appendix A Repackaging the Router
Figure A-2
OL-17440-01