Abit AB-SA7 Manual page 56

4-10
Don't forget your password. If you forget the password, you will have to open the computer case and
clear all information in the CMOS before you can start up the system. But by doing this, you will have
to reset all previously set options.
APIC Mode:
Two options are available: Enabled or Disabled. If you set to Enabled, the next item will be available to
choose. When you set it to Disabled, the system will use the default six PCI IRQs for all devices, and will
not increase the number of PCI IRQs.
 MPS Version Control For OS:
This option specifies which version of MPS the motherboard will use.
Three options available: 1.1 ( 1.4. MPS stands for Multi-Processor Specification. If you use an older
OS for dual processor executing, please set this option to 1.1.
OS Select For DRAM > 64MB:
Two options are available: Non-OS2 or OS2. The default setting is Non-OS2. When the system memory
is bigger than 64MB, the communication method between the BIOS and the operating system will differ
from one operating system to another. If you use OS/2, select OS2; if you are using another operating
system, select Non-OS2.
Report No FDD For WIN 95:
Two options are available: No or Yes. The default setting is No. When you running some older Windows
operating system (such as: Windows
No.
Small Logo(EPA) Show:
Two options are available: Disabled or Enabled. The default setting is Disabled. If you set to Enabled,
when computer reboot then you can see the EPA logo on the up right corner of the screen.
SA7
Notice
®
95) without floppy drive, set this item to Yes. Otherwise, set it to
Chapter 4