Ink Refill System; Waste Tank - AGFA Printer Operator's Manual

:ANAPURNA L/XL

5.6. Ink Refill System

- Wrong ink in Main ink tank:
-
Observed during ink-fill:
- Press emergency stop.
- Drain main tank, taps are situated behind a plate, under the Ink Tank Indicator.
- Rinse the main tank with cleaning solution, by using a squeeze bottle.
- Fill the ink tank again, and bleed the ink-filter
- The Ink filters are situated behind the Refill System panel
-
Observed during printing:
- The customer needs to call the Service Engineer
- "Empty" and "Feeding" led stay lighted ON:
-
Operator:
- Check the ink level in the tank visually
- Push the Manual Feed button
If the problem persists....
- Push emergency stop and restart the system
If the problem persists....
- Call the Service Engineer

5.7. Waste Tank

- When the waste tank is full, the blue lamp
will flash on the Signal tower, together with
a beep-alarm.
- The waste tank is located under the conveyor belt,
on the Purge-side of the engine.
Open the tap underneath to empty the tank.
- Make sure the UV-ink is kept separately from
solvent ink, do not mix them in a waste container.
AB] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ] ]
– what can go wrong...
Loosen top cap (2) of filter
Push "Manual feeding" button
till ink drips out of top cap
Close top cap, tighten by hand
1 5
]
OPERATOR MANUAL
8/09/2006
]