Table of Contents
Advertisement
16.13 Cleaning the drip tray
ATTENTION!
Heat may damage the drip tray.
▶
Do not dry the drip tray in the hot cooking compart-
ment.
▶
Do not clean the drip tray in the dishwasher.
1.
Read the information on cleaning products.
→ Page 27
2.
Clean the drip tray using a dish cloth and hot soapy
water.
3.
Rinse thoroughly with clean water.
4.
Dry with a soft cloth.
5.
Leave the drip tray to dry with the lid open.
6.
Rub the seal on the lid until dry.
16.14 Cleaning the water tank
1.
Read the information on cleaning products.
→ Page 27
2.
Clean the water tank using a dish cloth and hot
soapy water.
3.
Rinse thoroughly with clean water.
4.
Dry with a soft cloth.
5.
Leave the water tank to dry with the lid open.
6.
Rub the seal on the lid until dry.
16.15 Cleaning the tank recess
1.
Read the information on cleaning products.
→ Page 27
2.
Wipe the tank recess dry after every use.
16.16 Cleaning the steam outlet in the
cooking compartment
1.
Read the information on cleaning products.
→ Page 27
2.
Clean the steam outlet in the cooking compartment
with hot soapy water and a cleaning sponge or soft
washing-up brush.
16.17 Cleaning function
You can use the cleaning function to clean the appli-
ance.
Descaling
To ensure that your appliance continues to operate cor-
rectly, it must be descaled regularly.
How frequently you need to run the descaling pro-
gramme depends on the water hardness and how
many times you have used the steam-assisted opera-
tions. By showing
on the display, the appliance indic-
ates when only another 5 or fewer steam-assisted oper-
ations are possible. If you do not carry out descaling,
you can no longer set any operation with steam.
Descaling will take around 32 minutes in total.
Descaling consists of two automatic steps.
¡ Descaling, duration approx. 31 minutes
¡ Rinse cycle after descaling, duration ap-
prox. 1 minute
For reasons of hygiene, the descaling programme must
be run in full.
If you interrupt the descaling programme, you can no
longer set any operation with steam. To ensure that the
appliance is ready for operation again, run the rinse
cycle.
Starting the descaling process
It takes around 31 minutes to descale your appliance.
ATTENTION!
Using non-recommended descaler may damage the
appliance
▶
Only use the descaler recommended by us for the
descaling programme. The length of time for which
the descaler is left to work is based on this product.
If descaling solution comes into contact with the control
panel or other delicate surfaces, it will damage them.
▶
Remove descaling solution immediately with water.
1.
Use the function selector to select .
a The display shows the duration of the descaling pro-
gramme. You cannot change the duration.
2.
Open the tank cover.
3.
Remove the drip tray and empty it.
4.
Slide the empty drip tray in fully.
5.
Remove the water tank.
6.
Mix water with descaler to make a descaling solu-
tion.
Mix 250 ml water with 50 ml liquid descaler to
‒
make a descaling solution, or dissolve a descal-
ing tablet, weight 18 g, in 250 ml water for
5 minutes.
7.
Pour the descaling solution into the water tank and
slide the water tank in fully.
8.
Close the tank cover.
9.
Press
a The appliance is descaled.
a The remaining time counts down on the display.
a Once the descaling programme has run through to
the end, an audible signal sounds. The appliance
pauses.
10.
Open the tank cover.
11.
Remove the drip tray, empty it and slide it in.
12.
Remove the water tank, rinse it thoroughly, fill it with
fresh water and slide it in.
13.
Close the tank cover.
14.
Press
a The appliance is rinsed automatically twice. Once
the rinse cycle has run through to the end, an aud-
ible signal sounds.
Note: Observe the mixing ratio for the descaler.
Liquid descaler (order number 00311680): Mixing ratio
of 1:5, mix 50 ml descaler with 250 ml water.
Descaling tablets (order number 00311864): Dissolve
one descaling tablet, weight 18 g, in 250 ml water for
5 minutes.
Rinsing
If you have not used the steam function for a long time,
rinse the appliance.
To ensure that your appliance stays clean, you can
pump water through the pipe system. The appliance
then drains the water into the drip tray.
Note: After running the rinse cycle, loosened limescale
particles may be in the collecting container. This is nor-
mal and does not affect operation.
Cleaning and servicing en
29
Advertisement
Table of Contents
