Manual Focus
The camcorder's Full Range AF system offers
continuous shooting ability from close-up (as
close as approx. 5 cm (2") to the subject) to
infinity.
However, correct focus may not be obtained
depending on the shooting condition. In this
case, use the manual focus mode.
1
Set the Power Switch to "REC".
FOCUS
1 1 1 1
2 2 2 2
SET
2
Set the recording mode to "
3
Press FOCUS. The manual focus indicator
appears.
4
Press
or
to focus on a subject.
1
2
●
When the focus level cannot be adjusted any
further or closer, "
" or "
5
Press SET. Focus adjustment is complete.
To reset to Auto Focus
Press FOCUS twice.
Manual focus is recommended in
situations listed below.
●
When two subjects overlap in the same scene.
●
When illumination is low.*
●
When the subject has no contrast (difference in
brightness and darkness), such as a flat, one-
color wall, or a clear, blue sky.*
●
When a dark object is barely visible in the LCD
monitor or the viewfinder.*
●
When the scene contains minute patterns or
identical patterns that are regularly repeated.
●
When the scene is affected by sunbeams or
light reflecting off the surface of a body of water.
●
When shooting a scene with a high-contrast
background.
* The following low-contrast warnings appear
blinking:
,
,
and
Manual focus indicator
M
".
pg. 18)
(
" will blink.
.
FEATURES FOR RECORDING
Exposure Control
Manual exposure control is recommended in
the following situations:
●
When shooting using reverse lighting or when
the background is too bright.
●
When shooting on a reflective natural
background such as at the beach or when
skiing.
●
When the background is overly dark or the
1
subject is bright.
Select
2
SET
1
Open the LCD monitor fully.
2
Set the Power Switch to "REC".
3
Set the recording mode to "
4
Press MENU.
5
Select "FUNCTION", press SET or
6
Select "EXPOSURE", press SET or
7
Select the appropriate exposure, press SET
or
.
2
●
To brighten the image, press 3. To darken the
image, press 4. (maximum +/-6)
8
Press MENU.
NOTES:
●
If the adjustment does not cause any visible
change in brightness, set "GAIN UP" to "AUTO".
(
pg. 22, 23)
●
You cannot use the manual exposure control at
the same time when "PROGRAM AE" is set to
"SPOTLIGHT" or "SNOW" (
the backlight compensation.
27
EN
±
EXPOSURE
0
M
".
pg. 18)
(
.
2
.
2
pg. 30), or with