Table of Contents
Advertisement
en Troubleshooting
Fault
Drum jerks after the
programme starts.
Vibrations and move-
ment of the appliance
whilst spinning.
Heavy foam build-up
i-DOS
i-DOS
cannot be actuated.
High spin speed not
reached.
The spin programme
does not start.
50
Cause and troubleshooting
This is caused by an internal motor test.
Not a fault – no action required.
▶
Appliance is not correctly aligned.
Aligning the appliance
▶
The appliance feet are not fixed.
Secure the appliance feet. Aligning the appliance
▶
Transit bolts have not been removed.
Removing the transit bolts
▶
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 35.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Intelligent dosing is not intended for this programme.
Not a fault – no action required.
▶
Programme progress does not allow intelligent dos-
ing.
No remedial action possible.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
is activated.
Select the programmes that are suitable for the
▶
type of fabric.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the
programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Advertisement
Table of Contents
