Bump Starting - Fiat 500 Quick Manual To Repairs

Nuova 500
Emergency procedures
29
FLAT HIGH-VOLTAGE BATTERY AND 12V BATTERY
In this condition it is possible to move the car for a few metres,
positioning the ignition device on ENGINE and putting the
transmission in position N.

BUMP STARTING

Never bump start the motor by pushing, towing or driving downhill.
IMPORTANT
Remember that the brake servo and electric power steering system
(where provided) are not active until the ignition device is in the
ENGINE position. A much greater effort will therefore be required to
use the brake pedal or turn the steering wheel.
RECHARGING THE 12V BATTERY
IMPORTANT
Wait for at least one minute before disconnecting and then
reconnecting the electrical supply to the battery after turning the
ignition device key to STOP and closing the driver's door.
Charging should be slow at a low ampere rating for approximately
24 hours.