Remote Id Setup Mode - Denon AVR-X3200W Service Manual

4. Remote ID Setup Mode

4.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are used in the same
room.
4.2. Starting up
While holding down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" simultaneously, press the power button to
turn on the power.
Select the "6. REMOTE ID" using the "TUNER PRESET CH +/-" button, then press the "STATUS" button to confirm.
4.3. Operations
(1) When Remote ID Setup mode is activated, the following message is displayed.
FLD
R E M O T E
(2) Press the desired "QUICK SELECT 1 - 4" button.
Button
QUICK SELECT 1
QUICK SELECT 2
QUICK SELECT 3
QUICK SELECT 4
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
Only "QUICK SELECT 1 - 4" and the POWER button on the unit can be used in Remote ID Setup Mode.
b
The remote ID of the remote control supplied with this unit cannot be changed.
b
NOTE :
If the ID of the unit and remote control do not match, "AVAMP z " appears on the display of the unit when the remote
control is used.
( z : own remote control ID)
I D ?
Display
R E M O T E I D
R E M O T E I D
R E M O T E I D
R E M O T E I D
61
1
2
3
4