Table of Contents
Advertisement
Pin
Description
No
75
AGND
76
MIC+
77
VREF+/CIDIN+
78
RSTN
79
VDDIO
80
VSS
Note:
JACK DETECTION; Detect if a Headset is inserted into the JACK or not. Without a Headset, 1.5V
is measured at pin 23, while with a Headset, 0V is measured at pin 23.
27. EEPROM LAYOUT (BASE UNIT)
27.1. Scope
The purpose of this section is to describe the layout of the EEPROM (IC3) for the KX-TCD530
Base Unit.
The EEPROM contains hardware, software, and user specific parameters. Some parameters are
set during production of the base e.g. crystal frequency adjustment at address 0286, some are
set by the user configuration e.g. ringer volume at address 02C5, and some are set during
normal use of the phone e.g. Caller ID data at address 096A..0FDB.
27.2. Introduction
The base unit uses a 128K bit serial EEPROM (IC3) for storing volatile parameters. All
parameters are set up before the base leaves the factory. Some of these are vital for the
operation of the hardware so a set of default parameters is programmed before the actual
hardware fine-tuning can be initiated. This document lists all default settings with a short
description.
In the tables below values in a range that are similar are not repeated; i.e. Address 00 to 01
contains the value 00 simply means that the value 00 is repeated in all addresses in the range.
All values in this document are in hexadecimal notation.
Initial Type
F
The data initialized by only F command
0
The data initialized by F and 0 command
1
The data initialized by F, 0 and 1 command
2
The data initialized by all command (F,0,1,2)
I/O
Connection
A,O
A,I
A,O
VREF+
D,I
-
-
90
at Normal mode
-
-
Description
at Reset
O
O
I
O
O
O
I
O
-
-
-
-
Advertisement
Table of Contents
