Removing The Fpcs Before Installing The Mx960 Router Without A Lift - Juniper MX960 Instructions Manual

Removing the FPCs Before Installing the MX960 Router Without a Lift

When the DPC is out of the chassis, do not hold it by the ejector handles, bus bars,
or edge connectors. They cannot support its weight.
Do not stack DPC on top of one another after removal. Place each one individually
in an electrostatic bag or on its own antistatic mat on a flat, stable surface.
Figure 6: Removing a DPC
To remove an FPC (see Figure 7):
Have ready an antistatic mat for the FPC. Also have ready rubber safety caps for
1.
each PIC using an optical interface on the PIC that you are removing.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
2.
connect the strap to one of the ESD points on the chassis.For more information
about ESD, see Preventing Electrostatic Discharge Damage to an M Series, MX
Series, or T Series Router.
Simultaneously turn both the ejector handles counterclockwise to unseat the
3.
FPC.
Removing the FPCs Before Installing the MX960 Router Without a Lift
7