Priming The Pump - Simpson SSTP71007 Use And Care Manual

This pump will not prime when dry. Running the pump dry without priming can damage
the pump assembly and seals. Damage caused by running dry is not covered under
warranty. To avoid damaging the seals and pump assembly, do not run the pump when
it is dry without priming.

Priming the pump

1. Remove primer funnel cover.
2. Pour water into the primer funnel until pump is full of water.
Pumping volatile, flammable, or corrosive liquids could cause pump damage, fire, or
explosion resulting in severe injury and/or death. To avoid these hazards, do not attempt
to pump volatile, flammable, or corrosive liquids.
Page 14
PRIMING THE PUMP
PUMP PRIMING
1. Primer funnel cover
2. Gasket
3. Primer funnel
VOLATILE LIQUIDS
1
2
3