Wireless Settings - Hawking HWRGM1A Install Manual

WIRELESS SETTINGS

This page will guide you through your initial setup for wireless access. If you do not wish to use
wireless access in your network you may select "Disable". Otherwise select "Enable" to allow
wireless access and click NEXT to continue with your wireless settings.
Mode: AP (Access Point) mode is the default setting for your Wireless Router. AP mode is for basic wireless access
and it is recommended that you do not change this setting unless you are familiar with advanced wireless modes.
Band: Hawking recommends using B+G for your band settings. The band settings let you set your wireless access for
802.11b, 802.11g or both networks.
ESSID: The SSID is the identification name of your wireless network. Your individual computers will us e this ID to
recognize and connect to your network. The default ID of your network is: Hawking.
Channel #: Lets you select the channel number your wireless network operates on. You will not need to change this
unless there is wireless interference within your network.
Select NEXT to continue
HWRGM1A Hawking Technologies, Inc. P 8