Table of Contents
Advertisement
3. REMOVAL OF DVD DECK PARTS
NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the
disassembly is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
3-1: TRAY (Refer to Fig. 3-1-A)
1.
Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the 2 supports 1 and remove the Tray.
2.
1
Tray
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 3-1-B so that the each markers are met.
3-2: TRAVERSE ASS'Y (Refer to Fig. 3-2-A)
Remove the screw 1.
1.
Unlock the 2 supports 2.
2.
3.
Remove the Insulator (R) from the Loader Sub Ass'y.
4.
Remove the Traverse Ass'y.
DISASSEMBLY INSTRUCTIONS
Loader Ass'y
1
Fig. 3-1-A
Loader Ass'y
Tray
Fig. 3-1-B
Loader Sub Ass'y
Traverse Ass'y
• Screw Torque: 2.0 ± 0.5kgf•cm
NOTE
1.
In case of the Traverse Ass'y, install it from (1) to (4) in
order. (Refer to Fig. 3-2-B)
2.
In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 3-2-C.
Loader Ass'y (Bottom Side)
(3)
(2)
B3-1
1
2
2
Insulator (R)
(3)
(3)
(1)
(4)
(4)
Check Lock
Loader Ass'y
Check Hook
Fig. 3-2-A
Rack Loading
Holder Traverse
Traverse Ass'y
Fig. 3-2-B
Fig. 3-2-C
Advertisement
Table of Contents
