Removal Of Dvd Deck Parts - Toshiba VTW2185 Service Manual

3. REMOVAL OF DVD DECK PARTS

NOTE
1. Do not disassemble the DVD DECK PARTS except
listed parts here. Minute adjustments are needed if the
disassemble is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
3-1: TRAY (Refer to Fig. 3-1-A)
1. Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
Unlock the support 1 and remove the Tray.
2.
1
Tray
NOTE
1. In case of the Tray installation, install them as the
circled section of Fig. 3-1-B so that the each markers
are met.
Tray
Main Frame Ass'y
3-2: MAIN CHASSIS ASS'Y (Refer to Fig. 3-2-A)
1. Remove the Main Chassis Ass'y from the Insulator (R).
Unlock the support 1.
2.
3. Remove the Main Chassis Ass'y.
Main Frame Ass'y
Main Chassis Ass'y
All manuals and user guides at all-guides.com
DISASSEMBLY INSTRUCTIONS
Main Frame Ass'y
Fig. 3-1-A
Fig. 3-1-B
Insulator (R)
(Green)
1
Fig. 3-2-A
NOTE
1. In case of the Main Chassis Ass'y, install it from (1) to
(6) in order. (Refer to Fig. 3-2-B)
Rack Loading
1
Move it to the direction
of the arrow.
Main Frame Ass'y
3-3: RACK LOADING/MAIN GEAR/ RACK LOADING
SPRING (Refer to Fig. 3-3)
Press down the catcher 1 and slide the Rack Loading.
1.
2. Remove the Rack Loading, Rack Loading Spring and
Main Gear.
Rack Loading Spring
1
3-4: CLAMPER ASS'Y/INSULATOR(R)/LEVER SWITCH
(Refer to Fig. 3-4-A)
Remove the screw 1.
1.
2. Remove the Lever Switch.
3. Remove the 2 Insulator (R).
4. Press the Clamper and rotate the Clamper Plate
clockwise, then unlock the 3 supports 2.
5. Remove the Clamper Plate, Clamper Magnet and
Clamper.
Insulator (R)
(Green)
Clamper Plate
Clamper Magnet
Lever Switch
1
B3-1
Main Chassis Ass'y
2
3
6
4
5
6
Check Lock
4
Fig. 3-2-B
Rack Loading
Main Gear
Main Frame Ass'y
Fig. 3-3
Insulator (R)
(Green)
Main Frame
2
2
Clamper
2
Fig. 3-4-A
5