Table of Contents
Advertisement
1. Navigate to Learning » Examples » Hardware Input and Output » NI-USRP » NI-
USRP.
2. Select Rx Continuous Async. Click Create.
3. Run USRP Rx Continuous Async.
If the device is receiving signals you will see data on the front panel graphs.
4. Click STOP to conclude the test.
Verifying the Device Connection Using LabVIEW
Run a VI to confirm that the device transmits and/or receives signals and is
connected correctly to the host computer.
1. Create a sample project in LabVIEW by selecting File » Create Project »
NI-USRP.
2. Select the NI-USRP Simple Streaming sample project template and click Next.
3. Run the appropriate streaming VI according to your USRP RIO device.
Device
USRP-2940/2942/2943/2944
USRP-2945
If the device is transmitting and/or receiving signals, the front panel graphs
display waveform data.
4. Click STOP to conclude the test.
Troubleshooting
If an issue persists after you complete a troubleshooting procedure, search our
KnowledgeBase for additional information our technical support engineers create
as they answer common user questions and resolve unexpected issues.
Why Doesn't the Device Power On?
If you cannot power on the device, complete the following steps.
Verify that the device is connected to the power supply.
■
Verify that the power supply is functional.
■
USRP-2940/2942/2943/2944/2945 Getting Started
VI
Tx and Rx Streaming Host VI
Rx Streaming (Host) VI
17
© National Instruments
Advertisement
Table of Contents
