Panasonic TH-98SQE1W Operating Instructions Manual page 32

SLOT Settings
Press ENTER to open the SLOT Settings menu screen. Three sub-menu options are
available.
SLOT Status: Displays whether the SLOT module is on or off. Allows the change of
status via soft PSON signal (0.5s)
Boot Signal: Enables or disables sending of a PSON signal. The Display checks the
status signal of the SLOT at bootup in order to turn it on by sending a PSON signal if
it is off. Some SLOT's send incorrect information on their status during the bootup of
the Display, so they seem to be on even though they are off. For such non-standard
SLOT's, this option must be enabled. In this case, a PSON signal will be send for the
SLOT regardless of the received status information at bootup.
Powerdown: Turns the SLOT off via hard PSON signal (5s)
Recovery Mode: When this option is enabled and SLOT is on, if there is no video
for 10 seconds it resets hotplug. If there is no video available after 30 seconds it
reboots SLOT.
SLOT Always on: When this option is enabled, Power Mode will be forced to reactive
and greyed out in the menu and SLOT will not be set to standby.
Power Off Mode: When this option is Normal, wait for a response from SLOT.
After receiving the response, turn off the Display. When this option is Force, wait
for a response from SLOT for about 10 seconds. If there is no response, forcibly
turn off the Display. If SLOT Always On option is set as Enabled, this option will
not be available.
Note: This menu will not be available if SLOT is not supported or not connected to the unit.
English - 31 -