Maintenance; General; Cleaning; Display Light Bulb Replacement - Hatco Glo-Ray GRSDH-24 Installation And Operating Manual

GENERAL

Hatco Glo-Ray ® Merchandising Display Warmers
are designed for
performance, with minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
WARNING
To prevent any injury, discontinue use if power
cord is frayed or worn.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
WARNING
Unit is not waterproof. To avoid electrical shock
or personal injury DO NOT submerge in water.
Do not operate if it has been submerged in
water.

CLEANING

NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish marring its
appearance and making it susceptible to dirt
accumulation.
NOTICE
Only soft cleaning cloths with mild soap and
water should be
protector(s). Breath protector(s) are made of
shatterproof polycarbonate and will scratch or
crack if proper care is not taken.
To preserve the bright finish of the Glo-Ray
Merchandising Display Warmer, it is recommended
that the exterior and interior surfaces be wiped daily
with a damp cloth. Stubborn stains may be removed
with a good non-abrasive cleaner. Hard-to-reach
areas should be cleaned with a small brush and mild
soap.
Clean the glass side panels using a common
glass cleaner.
maximum durability
used to clean breath

DISPLAY LIGHT BULB REPLACEMENT

The display light is an incandescent light bulb which
and illuminates the warming area. The bulb has a
special coating to guard against injury and food
contamination in the event of breakage.
1. To replace a light bulb, disconnect the power
supply and wait until the unit has cooled.
2. Light bulbs have a threaded base. Unscrew the
light bulb from the unit and replace it with a new
specially-coated incandescent light bulb.
NOTE:
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food
holding areas must be used. Breakage of light
bulbs not specially coated could result in
personal injury and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350;
International fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Replacement Parts
when service is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
13

MAINTENANCE

WARNING
WARNING
fax 800-690-2966
WARNING
WARNING
parts do not have
Form No. GRSDM-1207
or
the