Installation; All Models; Location - Hatco Glo-Ray GRSDH-24 Installation And Operating Manual

ALL MODELS

®
Glo-Ray Merchandising Display Warmers are
shipped with most components pre-assembled.
Care should be taken when unpacking shipping
carton to avoid damage to unit and components
enclosed.
WARNING
To prevent any injury or damage to the unit
do not pull unit by power cord.
WARNING
To prevent any injury, discontinue use if power
cord is frayed or worn.
1. Remove unit from box.
2. Remove information packet. To prevent delay
in obtaining warranty coverage, fill out and
mail in the warranty card.
3. Remove tape and protective packaging from all
surfaces of unit.
CAUTION
The National Sanitation Foundation (NSF)
requires units over 36" (914 mm) in length or
weighing more than 80 lbs. (36 kg) to be either
sealed or raised on the installation surface. If
this unit cannot be sealed at the point of use, 4"
(102 mm) legs are included to allow for proper
cleaning access below unit.
WARNING
Do not lay unit on the side with the control panel
or damage to unit could occur.
4. Carefully lay unit on its side and install the four
legs. (Figure 6.)
5. Slide each side glass panel into the upper
channel, then lower the panel into the lower
channel. (Figure 7.)
6. The unit is supplied with product divider bars.
To install them, place the bars in the channels
provided. (Figure 8.) The bars can be readily
adjusted to separate your holding areas as
needed.

LOCATION

NOTE:
For proper operation and maximum performance,
locate the Merchandising Display Warmer in an area
where the ambient air temperature is constant
and is a minimum of 70°F (21°C). Areas which are
Figure 6. Leg Installation
Figure 7. Side Glass Panel Installation
Figure 8. Installing Product Divider Bars
susceptible to active air movements or currents
should be avoided, i.e., near exhaust fans or hoods
and air conditioning ducts.
For safe and proper operation, the unit must be
located a reasonable distance from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could
occur.
To avoid any injury or damage locate the unit
at the proper counter height, in an area that
is convenient for use. The location should be
level to prevent the unit or its contents from
accidentally falling, and strong enough to
support the weight of the unit and food
displayed.
11

INSTALLATION

WARNING
CAUTION
Form No. GRSDM-1207