Table of Contents
Advertisement
Chapter 1
Product Overview
•
•
•
Cisco MWR 1941-DC-A Router Front View
On the front panel, viewing from right to left, the Cisco MWR 1941-DC-A router (see
the orientation of the following components:
•
•
•
•
•
•
The location of the rack-mounting brackets is also shown facing front on the left and right sides of the
Note
router. Note how the brackets are attached to the left and right sides by wrapping around the air vent (see
the
install the mounting brackets).
OL-7872-04
Front access cabling
Three green chassis LEDs (see the
page 1-7
for a description):
Power, labeled PWR (indicates whether power supply is operational)
–
Status, labeled STAT (indicates whether software is up and running)
–
Activity, labeled ACT (indicates whether interrupts or packet transfers are running)
–
The Cisco MWR 1941-DC-A Router is normally shipped with:
–
Mounting rack-mount brackets already installed (as described previously) that allow the
Cisco MWR 1941-DC-A router to be positioned in an equipment rack.
A 2-port T1/E1-RAN, installed in two of the three 2-port T1/E1-RAN (positions 0 and 1) slots.
Auxiliary and Console ports.
Fixed Compact flash slot.
FE (FasatEthernet) ports.
A blank panel, installed in the network module slot.
Various LEDs (chassis, Fast Ethernet, and 2-port T1/E1-RANs), see the
description of the all the LEDs.
"Mounting the Cisco MWR 1941-DC-A Router" section on page 3-2
Cisco MWR 1941-DC-A Mobile Wireless Edge Router Hardware Installation Guide
"Cisco MWR 1941-DC-A Router Front View" section on
Hardware Description
Figure
1-4) shows
"LEDs"
section for a
for instructions on how to
1-7
Advertisement
Table of Contents
Troubleshooting
