Notice - Sanyo FW43D47F Owner's Manual

1 Notice

SANYO is a registered trademark of SANYO Electric Co., Ltd. and is used
by Funai Electric Co., Ltd. and Funai Corporation, Inc. under license from
SANYO Electric Co., Ltd.
Any liability related to SANYO products, including design and quality, is
the sole responsibility of Funai Electric Co., Ltd. and Funai Corporation,
Inc.
Please contact Funai Corporation, Inc. for any questions or claims related
to SANYO products: www.sanyo-av.com
Funai Corporation reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
The material in this Owner's manual is believed adequate for the
intended use of the system. If the product or its individual modules or
procedures are used for purposes other than those specified herein,
confirmation of their validity and suitability must be obtained. Funai
Corporation warrants that the material itself does not infringe any United
States patents. No further warranty is expressed or implied.
Funai Corporation cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result of the content
in this document. Errors reported to Funai Corporation will be adapted
and published on the Funai Corporation support website as soon as
possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although it has
effective pixels of 99.999% or more, black dots or bright points of light
(red, green or blue) may appear constantly on the screen. This is a
structural property of the display (within common industry standards) and
is not a malfunction.
Warranty
No components are user serviceable. Do not open or remove covers to
the inside of the product. Repairs may only be done by service centers
and official repair shops. Failure to do so shall void any warranty, stated
or implied.
Any operation expressly prohibited in this Owner's manual, any
adjustments or assembly procedures not recommended or authorized
in this Owner's manual shall void the warranty.
Federal communications commission notice
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to
●
which the receiver is connected.
Consult the dealer or an experienced radio or television technician for
●
help.
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Declaration of conformity
: SANYO
Trade name
: Funai Corporation, Inc.
Responsible party
: FW43D47F
Model
: 12489 Lakeland Road, Santa Fe Springs, CA
Address
90670, USA*
: 1 866 212 0436
Telephone number
* This is not the mailing address for Open Source Software or Customer
service.
Modifications
This apparatus may generate or use radio frequency energy. Changes or
modifications to this apparatus may cause harmful interference.
Any modifications to the apparatus must be approved by Funai
Corporation.
The user could lose the authority to operate this apparatus if an
unauthorized change or modification is made.
Cables
Connections to this device must be made with shielded cables with
metallic RFI / EMI connector hoods to maintain compliance with FCC
Rules and regulations.
Canadian notice
CAN ICES-3 (B)/NMB-3 (B)
Analog and digital television receiving apparatus, Canada BETS-7 /
NTMR-7.
Positioning the TV
Large screen TVs are heavy. 2 people are required to carry and handle
●
a large screen TV.
Make sure to hold the upper and bottom
●
frames of the unit firmly as illustrated.
Install the unit in a horizontal and stable
●
position.
Do not install the unit in direct sunlight or in a
●
place subject to dust or strong vibration.
Depending on the environment, the
●
temperature of this unit may increase slightly.
This is not a malfunction.
When installing this unit in a temperate environment, avoid a place with
●
rapid temperature changes.
Operating temperature: 41°F (5°C) to 104°F (40°C)
–
This unit should not be used in a tropical environment as it has not been
●
evaluated under such conditions.
No objects should be placed directly on or under this unit, especially
●
lighted candles or other flaming objects.
Depending on your external devices, noise or disturbance of the picture
●
and / or sound may be generated if the unit is placed too close to them.
In this case, please ensure enough space between the external devices
and the unit.
Do not insert the AC power cord into the power socket outlet before
●
all the connections are made.
Ensure that you always have easy access to the AC power cord and
●
outlet to disconnect the TV from the AC outlet.
Before you move the TV, disconnect attached cables to prevent
●
damage to connectors, especially the TV tuner.
Be sure to unplug the AC power plug from the AC outlet before moving
●
or carrying the unit.
When moving the TV and then setting it down, please be careful not
●
to pinch the AC power cord under the unit.
Do not place this unit in an area where it may be exposed to water, oil
●
or grease such as:
near a bathtub, basin, kitchen sink, washing tub, swimming pool,
kitchen exhaust fan, etc., or in a damp basement.
5 .
English