Squeegee Cleaning; Squeegee Blade Check And Replacement - Viper FANG15B Owner's Manual

SQUEEGEE CLEANING

NOTE
The squeegee must be clean and its blades must be in good condition in order to getting
a good drying performance.
CAUTION !
It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.

SQUEEGEE BLADE CHECK AND REPLACEMENT

1. Take off the squeegee as shown in the previous paragraph.
2. Check to see if the edge of the front/rear blades
3. Unscrew six the thumb nut (37) to get off the blades.
4. Check the front/rear blades for integrity, cut and tear
them.
5. Install the squeegee in the reverse order of removal.
BRUSH /PAD DRIVER CLEANING
CAUTION！
It is advisable to wear protective gloves when cleaning the brush/pad because there may be sharp debris.
1. Remove the brush/pad
2. Clean and wash the brush/pad with water and detergent.
3. Check the brush bristles for integrity and wearing status; if necessary, replace the brush.
4. Check the pad for wearing status; if necessary, replace the pad driver.
TANK/VACUUM GRID WITH FLOAT CLEANING AND COVER GASKET
CHECK
CAUTION！
It is advisable to wear protective gloves when cleaning the tank and vacuum/suction assembly because there
may be sharp debris.
1. Move the machine to the appointed disposal area.
2. Turn off the main switch (47).
3. Take off the recovery tank (2), clean and rinse both solution/recovery tank, and drain out.
4. Take off all vacuum kits, gasket ,filter , clean and re-install.
5. Check the recovery tank lids gasket ring and the vacuum rubber connector(18) between two tanks
are integrity or not.
NOTE
The gasket ring of recovery tank and the rubber connector between two tanks create
vacuum in the tank. If necessary, replace them. .
as shown in the previous paragraph.
7
are cracked or split, if necessary replace them with new.
s. If they are not adequate, overturn or replace
USER MANUAL