How To Disassemble And Clean - Hamilton Beach CJ27 Instructions Manual

How to Disassemble and Clean

w WARNING
Electrical Shock Hazard.
Do not immerse motor base in water or any other liquid.
NOTE: Fruits and vegetables may cause parts to discolor. To prevent
this, wash parts immediately after each use.
1. Unplug.
2. Rotate Spout into up position to
prevent drips on counter.
3. Remove Bowl Assembly by
unlocking Locking Latches.
4. Slide Pulp Bin away from Base.
5. Lift Juicer Cover off of Strainer
Bowl.
6. To remove Strainer Basket, turn
Strainer Bowl upside down and
carefully remove the Strainer
Basket. (It is recommended
to remove Strainer Basket over a sink.) Pull off Juice Spout from
Strainer Bowl and set aside.
Cleaning Blending Jar
1. Add 1 cup (237 mL) of warm water and 1 drop of dish soap.
2. Slide Switch to 2 (HI) and blend for 30 seconds.
3. Remove Jar from Base and remove Collar. Rinse and dry.
w CAUTION
Laceration Hazard.
The center of the strainer basket contains small, sharp blades to
process fruits and vegetables during the juicing function. Do not
touch blades when handling the strainer basket.
7. Wipe Base of Juice Extractor with a soft, damp cloth and dry.
8. Easy Sweep™ Cleaning Tool is the most effective way to clean
Strainer Basket. Using tool, hold Strainer Basket under running
water and brush inside and outside of Basket.
9. All removable parts are dishwasher-safe.
DO NOT use "SANITIZE" setting when washing in dishwasher.
SANITIZE cycle temperatures could damage your product. Do not
place the Motor Base in the dishwasher. Some part distortion may
occur if your household dishwasher's temperature is higher than
normal or if the parts are placed too close to the heating element.
NOTE: To assist with cleaning, soak the Strainer Basket in hot,
soapy water for approximately 10 minutes immediately after juicing
is completed. If pulp is left to dry on the basket it may clog the fine
pores of the filter mesh, thereby lessening the effectiveness of the
Juice Extractor.
9