Alfa Romeo Alfa 156 Sportwagon Q4 Manual page 24

– fasten the five bolts;
– lower the car and remove the jack;
– fit the jack back into its container,
stove it on the right side of the boot and
secure it with the safety belts provided for
the purpose
– tighten down the bolts in the
sequence shown in fig. 16.
Refitting a standard wheel
Following the procedure described previ-
ously, raise the car and remove the com-
pact spare wheel.
Proceed as follows:
– tighten the pin (A-fig. 17) in one of
the fastening bolt holes;
– fit the wheel to the pin and tighten the
four bolts available;
fig. 16
– remove the pin (A-fig. 17) and
tighten the last fastening bolt;
– lower the car and remove the jack;
then, tighten the bolts in the sequence
shown previously for the compact spare
wheel (fig. 15).
After refitting:
– deflate the compact spare wheel fully
and then arrange it in the proper space pro-
vided inside the boot. Take into account
that due to its technical features, the com-
pact spare wheel after being used and
deflated will not regain exactly it original
size. This is not a defect and does not alter
its operating properties;
A0B0692m
fig. 17
– put the jack back into its container
forcing it lightly to prevent it from vibrat-
ing when travelling;
– put the tools used back into the rele-
vant housings inside the container;
– stow the container complete with
tools on the compact spare wheel and
secure everything with the clamping
device (A-fig. 8).
WARNING
If the
wheel
replace the whole compact spare
wheel kit.
A0B0228m
compact spare
is damaged,
23