Alfa Romeo Alfa 156 Sportwagon Q4 Manual page 23

– loosen the fastening bolts by about
one turn (B-fig. 11);
–take the jack out of the relevant con-
tainer set on the right side of the boot
(fig. 12);
– place the jack under the car near the
wheel to be changed (fig. 13);
fig. 11
22
fig. 12
– work the jack crank (A-fig. 13), to
extend it until the groove (B-fig. 14) on
the upper part of jack is correctly inserted
on the lower profile of the body (C-
fig. 14) approx. 40 cm from the profile
of the wheelhouse;
– work the jack and raise the car until
the wheel is a few centimetres from the
ground;
A0B0747m
fig. 13
A0B0693m
fig. 14
– completely unscrew the fastening bolts
(B-fig. 11), and remove the wheel;
– make sure that the contact surfaces of
the compact spare wheel with the hub are
clean and free of impurities which may
later cause the fastening bolts to slacken;
– fit the compact spare wheel by match-
ing the one of holes (A-fig. 15) with
the corresponding pin (B);
A0B0691m
A0B0232m
fig. 15
A0B0745m