Replace The Swivel Filter; Replace The Swivel O Rings - North Star 49436 Owner's Manual

Replace the Swivel Filter

1. Remove the swivel piping from the cleaner:
a. Disconnect the hose connection from the top of the swivel.
b. Remove the swivel piping from the fixture in the housing.
2. Remove the bottom piece of the swivel piping.
3. Gently push a small screwdriver up into the bottom the swivel to dislodge the internal components
(shown below).
4. Clean the filter screen and check the O ring for wear or damage. Replace either defective
component.
5. Replace the O ring, filter screen and sieve holder in the top of the swivel as shown above.
6. Re-install the swivel piping and reconnect the hose.

Replace the Swivel O Rings

1. Disconnect the hose connection from the top of the swivel piping.
2. Remove the swivel piping from the swivel fixture in the housing.
3. Remove the bottom piece of the swivel as shown below.
4. Replace the O rings with replacements from the Easy Repair Kit.
5. Reinstall the bottom piece in the swivel piping.
6. Reinstall the swivel piping in the housing fixture.
7. Reconnect the hose to the swivel piping.
Page 12 of 16
.