Harman Kardon AVR 7200 Quick Start Manual page 3

FM Antenna
AUDIO RECORDER
Step 4. Connect AM and FM antennas (Fig. 4) (see page 15).
Step 5. Connect source components, as shown in Figures 4 and 5, and the
Device Connection Options chart on the back of this guide (see
pages 15–16).
AUDIO connections: Right channel (red) on source to right (red)
on AVR, and left channel (white) on source to left (white) on AVR.
DIGITAL AUDIO connections, if available: Choose either coax
(orange) to coax (orange) OR optical to optical for each device.
The Coax 1 input defaults to the DVD player, but may be reassigned.
Assign the other digital inputs and outputs as appropriate for your
equipment (see Step 7).
VIDEO connections: Choose component (Y/Pb/Pr – green/blue/
red), composite (yellow) or S-Video (4-pin) for each video source.
Connect the component, composite and S-Video Monitor outputs to
AM Antenna
REC/IN
PLAY/OUT
your Video Monitor (TV). Switch your TV set's input to match the type
of video used for the currently selected source.
Step 6. Plug all components into AC power outlets. The outlets on the back
of the AVR 7200 should be used only for low-current products, such
as CD or DVD players, and the total should not exceed 100 watts.
Basic Receiver Configuration
Step 7. Select digital inputs: If your DVD is connected to Coax 1, no adjust-
ment is needed. For any other digital-device connections, use the
front-panel Digital Select button and the arrow buttons to select an
optical or coax digital input (see pages 20 and 30).
Step 8. Select a surround mode: Press the Surround Mode Group button
on the front panel to select a Dolby
Selector button to select a Dolby Pro Logic
other modes later; see pages 20–21 and 28–30.)
CD PLAYER
L R Optical Coax
Figure 4 – Audio Connections
Dashed lines (– – – –) indicate coax and optical
digital audio connections. Choose either type
(but not both) for each digital audio source.
Step 9. Configure speakers: No action is needed if you have seven "small"
Step 10. Set the Output Levels with EzSet
® mode, and the Surround Mode
® mode. (You may select Step 11. Your system is configured – sit back and enjoy!
satellite-type speakers and a subwoofer. Otherwise, press the Speaker
button and then the Set and arrow buttons to select the correct
speaker choices for your system (see pages 21–23).
™
: Set the Volume to –15dB.
Sit in the listening position and hold the remote in front of you at
shoulder level, pointing it at the receiver. Press the EzSet button on
the remote, and then the SET button when it lights red. Following
the instructions in the remote's LCD display, press the
the remote until the display shows the number of speakers in your
system and then press the SET button again. Hold the remote steady
until the LCD display flashes a COMPLETE message (see pages 24–26).
SPEAKER AND AUDIO CONNECTIONS
⁄ button on