Hyundai stargazer 2022 Owner's Manual page 348

8. Insert the jack handle into the jack and
turn it clockwise, raising the vehicle
until the tire clears the ground. Make
sure the vehicle is stable on the jack.
9. Loosen the lug nuts with the wheel lug
nut wrench and remove them with
your fingers. Remove the wheel from
the studs and lay it flat on the ground
out of the way. Remove any dirt or de-
bris from the studs, mounting surfac-
es, and wheel.
10. Install the spare tire onto the studs of
the hub.
11. Tighten the lug nuts with your fingers
onto the studs with the smaller end of
the lug nuts closest to the wheel.
12. Lower the vehicle to the ground by
turning the jack handle counterclock-
wise.
OKS082016L OKS082016L
13. Use the wheel lug nut wrench to tight-
en the lug nuts in the order shown.
Double-check each lug nut until they
are tight. After changing tires, we rec-
ommend that an authorized HYUNDAI
dealer tighten the lug nuts to their
proper torque as soon as possible. The
wheel lug nut should be tightened to
11~13 kgf.m.
If you have a tire gauge, check the tire
pressure (see "Tires and Wheels" in chap-
ter 2 for tire pressure instructions.). If the
pressure is lower or higher than recom-
mended, drive slowly to the nearest ser-
vice station and adjust it to the recom-
mended pressure. Always reinstall the
valve cap after checking or adjusting tire
pressure. If the cap is not replaced, air
may leak from the tire. If you lose a valve
cap, buy another and install it as soon as
possible. After changing tires, secure the
flat tire and return the jack and tools to
their proper storage locations.
Information
Check the tire pressure as soon as possible
after installing a spare tire. Adjust it to the
recommended pressure.
08
OKS082018L OKS082018L
8-19