Connect The Radio Antennas; Connect The 12V Trigger Output; Connect To Ac Power; Set Up The Remote Control - Harman Kardon AVR 1565 Owner's Manual

AVR 1565/AVR 1566
Audio recorders
Connect an analog audio recorder's inputs to the AVR's analog audio Tape Out connectors.
You can record any analog audio input signal.
AVR Analog Audio
Recorder Connectors
Stereo Audio Cable
(not supplied)
Video recorders
Connect an analog video recorder's video input connector to the AVR's Video 2 Out
Composite Video connector, and its audio input connectors to the AVR's Video 2 Out
Analog Audio connectors. You can record any composite video signal.
AVR Analog
Video Connectors
AVR Analog
Audio Connectors
Analog Audio/Video
Cable (not supplied)

Connect the Radio Antennas

• Connect the supplied FM antenna to the AVR's FM 75 Radio Antenna connector. For
the best reception, extend the FM antenna as far as possible.
• Bend and fold the base of the supplied AM antenna as shown and connect the antenna
wires to the AVR's AM and Gnd connectors. (You can connect either wire to either
connector.) Rotate the antenna as necessary to minimize background noise.
AVR Radio Antenna
Connectors
FM Antenna (supplied)
AM Antenna
(supplied)
To Stereo Analog
Record Outputs
Analog Recording Device
To Analog Audio/Video
Record Inputs
Analog Video
Recording Device
Bend and fold base
Making Connections, continued,
and Set Up the Remote Control

Connect the 12V Trigger Output

If your system has equipment that can be controlled by a DC trigger signal, connect it to
the AVR's 12V Trigger connector with a mono 1/8-inch (3.5mm) mini-plug interconnect
cable. The AVR will supply a 12V DC (100mA) trigger signal at this connection whenever
it is powered on.
AVR
Device with Trigger
in Connector

Connect to AC Power

Connect the AC power cord to the AVR's AC Input connector and then to a working AC
power outlet.
AVR AC
Input Connector

Set Up the Remote Control

Install the Batteries in the Remote Control

Remove the remote control's battery cover, insert the three supplied AAA batteries as
shown in the illustration, and replace the battery cover.
NOTE: Remove the protective plastic from the AVR's front panel to keep it from reducing
the remote control's effectiveness.
Mono 1/8-inch
(3.5mm)
Mini-Plug
Interconnect
(not supplied)
AC Power
Outlet
Power Cord
(supplied)
15